Ives Door 7212V User Manual

Installation Instructions

7212V 3/4” Offset Jamb Mount Top Pivot

3/32” Allen

wrench

Right hand

installation

shown; left

Set

screw

hand opposite

Door

leaf

Right hand

installation

Left hand

installation

Jamb

leaf

Pivot

1. Prepare and mortise top of door and side jamb to receive pivot set. Determine pivot location

using dimensions on reverse side. The pivots are handed. To determine hand of door and

proper pivot position, see diagrams above.

2. Locate, drill, and tap 1/4-20 mounting holes for metal door or metal frame. Locate and drill

pilot holes for #14 wood screws for wood door or wood frame. Install pivot leafs with

1/4-20 x 3/4” FHMS or #14 FHWS screws provided.

3. Loosen set screw in pin leaf with 3/32” Allen wrench provided and remove pivot pin.

4. With door in open position (about 90° to jamb), carefully fit door onto bottom pivot at a slight

angle. Tip door into vertical position, aligning top pivot leafs in door and jamb. With pivot

leafs aligned, insert pivot pin into pivot set. Vertically align groove in pivot pin with set

screw in pivot leaf. Tighten set screw securely with 3/32” Allen wrench.

5. To remove door from jamb: Use 3/32” Allen wrench to loosen set screw in door pivot leaf.

Pull pivot pin out of pivots. Door can now be removed from opening.

CAUTION

Improper pivot set installation can lead to personal injury or property damage. Follow

all instructions carefully. For questions contact Technical Support at 1-888-371-7331.

31582 Rev. 4