Jenn Air Range JGR8895BD User Manual

30" (76.2 cm) Double Oven Gas Range  
PRODUCT MODEL NUMBER  
PRODUCT DIMENSIONS  
JGR8895BD  
B*  
Gas supply: This range is design-certified by CSA International for use  
with Natural gas or, after proper conversion, for use with LP gas.  
Provide a gas supply line of 3/4" (1.9 cm) rigid pipe to the range location.  
A smaller size pipe on longer runs may result in insufficient gas supply.  
Pipe-joint compounds that resist the action of LP gas must be used. Do  
not use TEFLON®† tape. With LP gas, piping or tubing size can be 1/2"  
(1.3 cm) minimum. Usually, LP gas suppliers determine the size and  
materials used in the system.  
C**  
If local codes permit, a new CSA design-certified, 4 to 5 ft (122 to 152.4 cm)  
long, 1/2" (1.3 cm) or 3/4" (1.9 cm) I.D., flexible metal appliance connector  
may be used for connecting range to the gas supply line.  
A
D
A 1/2" (1.3 cm) male pipe thread is needed for connection to the female  
pipe threads of the inlet to the appliance pressure regulator.  
A. 35⁷⁄₈" (91.1 cm) cooktop height  
(minimum) with leveling legs  
screwed all the way in*  
B. Model/serial/rating plates  
(located behind the control  
panel)**  
The supply line must be equipped with a manual shutoff valve. This valve  
should be located in the same room but external to the range.  
C. 46³⁄₄" (118.7 cm) overall height  
(minimum) with leveling legs  
screwed all the way in*  
D. 28¹⁄₈" (71.3 cm) depth with  
handle  
E. 26⁵⁄₁₆" - 27¼" (66.8 - 69.2 cm)***  
F. 29⁷⁄₈" (75.9 cm) width  
Electrical: The range must be electrically grounded in accordance with  
local codes and ordinances, or in the absence of local codes, with the  
National Electrical Code, ANSI/NFPA 70 or Canadian Electrical Code, CSA  
C22.1.  
F
E***  
If codes permit and a separate ground wire is used, it is recommended  
that a qualified electrical installer determine that the ground path is  
adequate.  
*Range can be raised approximately 1" (2.5 cm) by adjusting  
the leveling legs.  
A 120-volt, 60-Hz, AC-only, 15-amp fused, electrical circuit is required. A  
time-delay fuse or circuit breaker is also recommended. It is  
recommended that a separate circuit serving only this range be provided.  
Do not use an extension cord.  
**Model/serial/rating plates may be rotated up from behind the  
control panel for viewing from the front of the range.  
***Excludes handle. Dimension given is from wall to front of oven  
door and will vary based on electric outlet receptacle  
installation.  
†®TEFLON is a registered trademark of E.I. Du Pont Nemours and Company.  
CABINET OPENING DIMENSIONS  
Cabinet opening dimensions shown are for 25" (64.0 cm) countertop  
depth, 24" (61.0 cm) base cabinet depth and 36" (91.4 cm) countertop  
height.  
D
B
C
IMPORTANT: If installing a range hood or microwave hood  
combination above the range, follow the range hood or microwave hood  
combination installation instructions for dimensional clearances above  
the cooktop surface.  
A
E
Range may be installed with zero clearance to combustible construction  
at the rear and on the sides below the cooktop.  
NOTE: 24" (61.0 cm) minimum when bottom of wood or metal cabinet  
is protected by not less than 1/4" (0.64 cm) flame retardant millboard  
covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm)  
stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.  
30" (76.2 cm) minimum clearance between the top of the cooking  
platform and the bottom of an unprotected wood or metal cabinet.  
F
I
H
H
G
8¼"  
(21.0 cm)  
9¼"  
(23.5 cm)  
A. 18" (45.7 cm) upper cabinet to countertop  
B. 13" (33.0 cm) upper cabinet depth  
C. 30" (76.2 cm) min. opening width  
D. For minimum clearance to the top of the cooktop, see NOTE.  
E. 30" (76.2 cm) min. opening width  
F. 3" (7.6 cm) min. clearance from both sides of the range to the side  
wall or other combustible material.  
3"  
(7.6 cm)  
3½"  
10"  
(8.9 cm)  
(25.4 cm)  
5"  
(12.7 cm)  
3"  
(7.6 cm)  
G. 3" (7.6 cm) distance from wall  
H. Cabinet door or hinges should not extend into the cutout.  
I. Clearance for gas pressure regulator  
1"  
2¼"**  
(2.5 cm)  
(5.7 cm)  
1¼"*  
*Drill on centerline 1¼" (3.1 cm) from rear wall for gas supply  
line.  
(3.1 cm)  
15" (38.1 cm)  
gas line location  
3½"  
(8.9 cm)  
**Gas lines and electrical plugs must be installed within the  
shaded area to ensure proper alignment of this oven with  
cabinets.  
Because Whirlpool Corporation policy includes a continuous commitment to improve  
our products, we reserve the right to change materials and specifications without notice.  
Dimensions are for planning purposes only. For complete details, see Installation  
Instructions packed with product. Specifications subject to change without notice.  
Ref. W10162494  
10-16-08  
 

InFocus Home Theater Screen IN124STa User Manual
JBL Portable Speaker 24G AW User Manual
Jenn Air Cooktop 8112P341 60 User Manual
JL Audio Portable Speaker JLVR600CXi User Manual
JVC Camcorder GR AX940 User Manual
JVC Car Stereo System GET0163 001A User Manual
Kawasaki Grinder 840272 User Manual
Kelvinator Refrigerator ER 1642 T User Manual
Kenmore Double Oven 7909805 User Manual
Kidde Smoke Alarm KN COP DP LS User Manual